Ikea Fniss -> Hydroponic Tower

This model enables you to use your ikea fniss trashcan as a water reservoir for your hydroponic tower.The Ikea Fniss trashcan is quiet cheap (2.50€ in Germany) so its a good option especially for smaller towers.I designed a normal lid and one with a hole for cable and refill. There is a plug to close the hole too.This design uses the Module_Adapter_Custom.stl from the original design as connector to screw your tower on.I just glued everything together. The 4 quarters can be screwed together using m3 screws.Adjust to your needs. I provide the onshape project: LinkGuidePrint3 of “Fniss Lid quarter part” - from this printable page1 of “Fniss Lid quarter Part with hole” - from this printable page1 "Fniss Lid hole plug" - from this printable page1 “Module_Adapter_Custom.stl” - from the other printable pageAssebleeinter (or both) glue and screw all 4 lid plates togetherafter it dried, glue the “Module_Adapter_Custom” to your lid. This makes the whole connection even strongerJust snap