Thingiverse
IKEA Fridans mounting brackets
di vinnerB
6
Download
9
Likes
1
Makes
During a move I lost the original mounting brackets for one of my fridans blinders, so I recreated them based on another set I did not lose.
Remarks
Supports are propbably only required for the 90 degree overhang of the slide. However as they barely increase the print time and are easy to remove (contact Z distance = 0.1 mm), I used supports for all overhanging pieces.
Origninaly I made the brackets in PLA , but because some of my past PLA prints have warped after leaving them in the sun, I opted for PETG. The print turned out fine with prusa's default PETG print settings.
Remarks
Supports are propbably only required for the 90 degree overhang of the slide. However as they barely increase the print time and are easy to remove (contact Z distance = 0.1 mm), I used supports for all overhanging pieces.
Origninaly I made the brackets in PLA , but because some of my past PLA prints have warped after leaving them in the sun, I opted for PETG. The print turned out fine with prusa's default PETG print settings.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
