Ikea Hyllis 10cm Riser

I modified Danny Engeringh's IKEA Hyllis replacement foot in OnShape to give my Hyllis a boost!I liked the product but it is too short for my use so by adding about 10cm of height, it is just right.The legs sit about 2.5cm into the leg for stability.I printed this in PETG-CF with 4 walls and 25% infill. You could try in PLA but you should increase the walls and infill. TipsPrint the test piece and check the fit. If too loose, reduce size of the risers by 1-3%. Aim for a tighter fit as you can always tap the legs on with a hammer or mallet. I used 97% and it was still spacious.Print the parts but with a hot bed, especially if using A1. I set mine to 80 degrees with PETG-CF.If you make a mistake, the leg with original dimensions is available on a separate plate. Enjoy!Boost MeIf you found this useful, please leave me a boost.