Thingiverse
IKEA IVAR Hook snap-on
von AndreaSignoretto
14
Downloads
11
Likes
0
Makes
Hook that can fit IKEA IVAR side supports. Available in 12 and 6mm width of the hook tip.
The snap-on is pretty satisfying and avoids unintentional detachment of the hook.
Printed in PLA with 3 perimeters in 0.3mm layers and 20% fill in 18min on Prusa MK3S
The snap-on is pretty satisfying and avoids unintentional detachment of the hook.
Printed in PLA with 3 perimeters in 0.3mm layers and 20% fill in 18min on Prusa MK3S
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
