IKEA Kallax Drawer Extension

This 3-part extension increases the storage capacity of the IKEA Kallax double drawer insert module. The parts (back, left, and right) assemble without additional hardware and attach on top of the existing drawer with wood screws, nearly doubling its usable volume. Added height: 58 mm. The extension fits all variants of the IKEA Kallax double drawer module. PLA Basic is recommended for ease of printing, good surface finish, and cost-effectiveness, especially when making multiple drawers. Other filaments may be used but are not tested; PLA Matte may delaminate between layers. The total filament required for all three parts is 102 grams. One standard roll of filament is enough to make almost 10 drawers, or 5 double-drawer modules. Assembly Steps:Assemble the three parts and place them on top of the drawer.Use an awl to mark the screw positions on the drawer’s side panels and the two front panel positions (left and right). Alternatively, a marker or pencil can be used, but an awl allows m