Ikea Lack drawers

I designed these drawers for my Ikea Lack printer table as a fine addition to the included drawer of my Creality CR6 SE. They are large enough to fit a Capricorn-Ziplock-Bag and the most common tools.

The parts (beside left/right/middle rail [Schiene links/rechts/mitte]) have to be printed twice:
- Gnob (Griff)
- Drawer (Schublade)
- Pull out protection (Ausziehschutz)
- Back lid (Deckel)


Some additional information about printing:
- All parts are aligned ready to print.
- The side rails (Schiene links and rechts) need support, suggested distance between object and support is 0,12mm (or less for better results). Please use sntandard support (no tree-support!), otherwise the rails will be too unstable to be printed properly.
- Infill as you like, i printed mine with 100% just to be sure there are no faults in the visible surface.
- Clean the bed properly and heat up to a higher temperature to increase adhesion (i used 65°C to make sure the parts dont come off the bed).