IKEA Lack Enclosure - My extra bits

I built the IKEA Lack enclosure for my new printer. The set found on Thingiverse suggests two Lack tables stacked.

Well. I want my printer at a reasonable hight, so I wanted three tables stacked.

That means I needed an extra set of bracket for the legs. Here are my version.

I also wanted lights.
Went to IKEA to find the good old led strips. They weren't there anymore.
But they had Ledberg - some flat, round base, led lights.
I wanted them to point directly at the bed, so I made some corner brackets that fits onto the legs.

OBS! Print the Ledberg bracket with a brim. Just saying.

And with three tables stacked, I suggest you consider a angle bracket to tix the upper table to the wall.

And there is also a wire gromet so that you can take the wires from the PSU through the table. That wil give you more wire and you don't have to extend the wires.
I used a 22mm spade drill.