IKEA LACK Setup By Monberg75

I made this setup for my Ender 3 printer, as I was limited on space.

The raisers are 10 cm in height, and fit the legs of the table. On top of the raiser, there is a hole for a 5x5 mm cube magnet, and then i used a roofing nail in middle of the table legs for the upper table. Just to get it a bit more stable. It can be left out without a problem.

You need to print 4 raisers (Ask me, then ill make them for your height and put them in the collection)

You need to print 4 upper corners for the top.

For the top and bottom, i used super magnets which are 4x1mm, and I've made a hole fitting those magnets, so you can superglue them in the holes on both top and raiser.

Link for disc magnets:
https://www.supermagnete.de/eng/disc-magnets-neodymium/disc-magnet-diameter-4mm-height-1mm-neodymium-n45-nickel-plated_S-04-01-N

Link for cube magnets:
https://www.supermagnete.de/eng/cube-magnets-neodymium?length-or-diameter=5.00,12.00&lifting-force-kg=0.00,6.30

For the sides i've ch