Thingiverse
Ikea Lack Table Filament Guide
von kamilzierke
13
Downloads
2
Likes
0
Makes
I couldn't find a suitable filament guide, so I've designed one myself.
Both top and bottom parts are 4mm wide inside except of the last 1mm which is narrower to create a ledge and prevent the PTFE tube from sliding out.
You need to drill a 10mm wide hole in the table (that was the drill bit I had).
Bottom part has countersunk holes for self drilling screw, to prevent it from poping out from the table.
Both top and bottom parts are 4mm wide inside except of the last 1mm which is narrower to create a ledge and prevent the PTFE tube from sliding out.
You need to drill a 10mm wide hole in the table (that was the drill bit I had).
Bottom part has countersunk holes for self drilling screw, to prevent it from poping out from the table.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
