Ikea Lack Table Spacers

I was displeased with the commonly available Ikea Lack Table spacers, since the screws in that project were placed in places where only cardboard was. Also, the legs screws were missing a height offset, which resulted in screws hitting each other inside the leg if they were long enough. Additionally since they were placed so low in leg it resulted in a big leverage, that cold rip them out from the print.

The project addresses those issues;
- there are 2 screw holes that enable you to screw into the wooden block in the table (Lack Table has 4 small wooden blocks in each corners to mount the legs, the rest of it is a honeycomb shaped paper)
- additional 4 screw holes to screw into paper (they don't have to be used)
- leg holes are done with offset to prevent screws from hitting each other inside the leg and they are moved away from the leg end to prevent breaking the print.

Keep in mind that this spacer doesn't have any holes to mount the glass or magnets.