Thingiverse
Ikea Läck Filament guide
door Third_Man
3
Downloads
2
Likes
0
Makes
Hello all, this is my first real design which i prototyped from a P clip.
I made this since i used nylon P clips and I needed more but shipping from china would take to long. So made my own little P clip that is used for filament guiding.
Currently I have them mounted on the side of my Ikea Läck and can be easily installed and used.
The square side is the side that goes on the wall, I used 4X20 screws (metric) and the hole for the filament is 6mm diameter (same as for the screw)
No supports are needed for this print, it takes me around 10 minutes to print one in 100% infill.
I made this since i used nylon P clips and I needed more but shipping from china would take to long. So made my own little P clip that is used for filament guiding.
Currently I have them mounted on the side of my Ikea Läck and can be easily installed and used.
The square side is the side that goes on the wall, I used 4X20 screws (metric) and the hole for the filament is 6mm diameter (same as for the screw)
No supports are needed for this print, it takes me around 10 minutes to print one in 100% infill.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
