IKEA Method/Sektion leg extension

A simple leg extension for the new METHOD/SEKTION legs (905.560.71). (Adds 4cm)I recently renovated an apartment and configurated an IKEA kitchen, unfortunately the SEKTION legs, which are the base for the IKEA METHOD system, are only available up to 11 cm. Because I'm a tall guy, I needed a bit more so I constructed these simple leg extensions.The SEKTION legs fit inside the print and because of a relatively tight ( but not stressed ) fitting, also on the hollow parts at the bottom of the legs, it is super stable and doesn't come apart easily.I printed the modell using PETG-CF, because the finished part will be under constant stress and i wanted to make sure, the prints will last.I used Eryone PETG-CF Filament for the print, and although there were Problems with the extrusion at the start of each print (like blobs and stuff like that), i was pretty pleased with the final result. The finish is great and there were no visible flaws. ( keep in mind, you need a hardened steel nozz