Thingiverse
Ikea omlopp mount
von Wemaketo
4
Downloads
3
Likes
0
Makes
Found some Ikea omlopp lights and their power source and figured they would be a good fit for my printing operation.
I mounted one of the lights with the mount that came with it but that was the only mount it came with no worries 3d printing baby !
I found a nice design below for linear rail printer like the Ender Cr10 and Geeetech A series printers
https://www.thingiverse.com/thing:3129588
the last light was to be mounted on the bottom of a table, I found a design but it was not the best was a bit short and so there would be a space and it was not the smoothest.
So I quickly wiped up a design in fusion 360 and used on of these guys to mount the my last light... and Its really sturdy with just one
I mounted one of the lights with the mount that came with it but that was the only mount it came with no worries 3d printing baby !
I found a nice design below for linear rail printer like the Ender Cr10 and Geeetech A series printers
https://www.thingiverse.com/thing:3129588
the last light was to be mounted on the bottom of a table, I found a design but it was not the best was a bit short and so there would be a space and it was not the smoothest.
So I quickly wiped up a design in fusion 360 and used on of these guys to mount the my last light... and Its really sturdy with just one
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
