Ikea RIBBA Led Frame

It started as a wedding present, but quickly got out of hand so that it would be a shame not to share it.

Attention: You need a minimum buildplate of at least 235x235mm.

Parts


a 18650 Cell
Tp4056 Micro USB 5V 1A Charger Module
a LED-Stripe
two M3 Brass Inserts
some Wires
Superglue


First of all: You need to disassemble the LED Stripe Battery Pack.
It delivers the Switch and the Stripe for this Project.

After Printing the Base, Insert two brass M3 fittings on the side of it.

Scrape the battery poles free and solder two wires to the corresponding BAT+ and BAT- contacts of the TP4056.

Be careful not to unnecessarily heat the battery.

Then solder a new wire from OUT- to the negative pole of the LED strip. Between the positives and OUT+ you solder the switch.
Be patient as you thread the wire to the switch, it's pretty tight.

That’s it. Now glue the led strip in the edge of the frame. I don't particularly trust the adhesive strip, so I use a few drops o