Thingiverse
Ikea shelf support
von Dannysx
0
Downloads
0
Likes
0
Makes
Today when we have a COVID-19 Crisis i made a shelf support because i can't buy this.
I printet this with PLA but this is too weak i recommend use ABS :)
90-100% Fill this not cost so much.
I Made this with my Creality Ender 3 v2
I printet this with PLA but this is too weak i recommend use ABS :)
90-100% Fill this not cost so much.
I Made this with my Creality Ender 3 v2
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
