IKEA Skådis Tool Holder Set

A set of 3D printed tool holders for the IKEA Skådis pegboard – designed to keep your workshop organized.

Included holders:
- Wrench holder (left / right)
- Caliper holder (lower / raised jaws)
- Drill bit holder (small / large)
- Bit holder (small bits / large bits)
- Hammer / pliers holder (wide / narrow)
- Saw holder
- Box holder
- Single-pin holders (long / medium / single pin)

Printing notes:
- I tried printing this set with both PLA and PETG. For my use case (a closed space with no heat source), PLA is sufficient.
- The example orientation shown in the attached photo has layers printed perpendicular to the pegboard for higher strength.
- 1 mm holes were added in the pins to improve strength by allowing extra perimeters to be printed.

This set was designed as part of my practice in 3D modeling while improving my skills for my current job.
I plan to add more holders over time, and I’d really appreciate any feedback or suggestions from the community.