Thingiverse
Ikea Slibb - hook
by Ebonix
0
Downloads
0
Likes
0
Makes
As the hook in my Ikea Slibb broke, I designed a replacement one.
It will snap fit like the original, however the fit is tight and the moving part in the hanger make it a bit tough to fit, but after a few tries, it worked for me :)
I printed the part out of PETG as it will be in direct sunlight.
(3 perimeter, 3 top/bottom layer and 20% infill)
It will snap fit like the original, however the fit is tight and the moving part in the hanger make it a bit tough to fit, but after a few tries, it worked for me :)
I printed the part out of PETG as it will be in direct sunlight.
(3 perimeter, 3 top/bottom layer and 20% infill)
Ebonix also publishes on
15 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
