Thingiverse
Illini Drink Coaster
door nealc10
7
Downloads
7
Likes
0
Makes
Printed with PETG. I used PrusaSlicer to change filament colors at these heights. Printed at 0.15mm.
0 White
1.85 mm change to blue (wish I had darker blue filament)
4.25 mm change to orange
6.5 mm change back to blue
The orange I used was translucent, so you can detect the infill a little at this thickness, but not too bad. The O.D. is 96mm/3.8", the height is 9mm/0.3". Designed using Morphi.
You can also set filament changes in Cura under Extensions/Post Processing/Modify G Code/Change at Z menu. In either slicer, I find I need to preview it carefully to get it right.
0 White
1.85 mm change to blue (wish I had darker blue filament)
4.25 mm change to orange
6.5 mm change back to blue
The orange I used was translucent, so you can detect the infill a little at this thickness, but not too bad. The O.D. is 96mm/3.8", the height is 9mm/0.3". Designed using Morphi.
You can also set filament changes in Cura under Extensions/Post Processing/Modify G Code/Change at Z menu. In either slicer, I find I need to preview it carefully to get it right.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!