illuminated Sheep

Sheep, which can be illuminated by RGB LED. Lipo battery and charge controller are integrated in the base.

The figure is printed without infill.
My slicer settings for the figure (Cura):
Layer hight: 0,1
Wall thickness: 1.2 (3 x 0.4 wall lines)
Top/Bottom Thickness: 0,8
Filling: 0%.
Combing mode: off

The white filament should be translucent. Suitable are e.g.: Geeetec or janbex.
Printing without filling is only possible without a hole at the bottom. Therefore the hole at the bottom has to be drilled after the printing.

Additional parts required:
Switch, e.g.: https://www.ebay.at/itm/332771007314
RGB-LED slow, e.g.: https://www.ebay.at/itm/282083177174
Lipo charging module, e.g.: https://www.ebay.at/itm/263782499558
Lipo, e.g.: https://www.ebay.at/itm/183257989282 (also 100mAh or smaller possible)
MICRO USB adapter, e.g.: https://www.ebay.at/itm/153515136089
22 Ohm Resistor

Base-bottom should be printed in white so that the LEDs of the charge controller are vi