Illumisphere

Have you seen that show "Dark" on Netflix? Well I made the flashlight from it. Haven't seen it? Just make sure you watch it in German as god intended.

Everything was printed in PLA. The handles and "Orb-Back" require some support, especially where that little piece touches the bed.

Layer editing is essential to give the top of the Orb a nice finish, and make sure to print with 100% infill.

Once the Orb is complete, break off the thin walls so the "Orb-back" may fit in place. I used tin foil to block out the light on the "Orb-back," which also reflects more light forward.

I then used lots and lots of hot glue to stick it all together. Good luck!

Electronics:

Battery Case:
https://www.amazon.com/gp/product/B06XWG75W2/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1

Light:
https://www.amazon.com/Atomic-Beam-TapLight-BulbHead-Astonishingly/dp/B07887Q53J/ref=asc_df_B07887Q53J/?tag=hyprod-20&linkCode=df0&hvadid=242074984067&hvpos=1o2&hvnetw=g&hvrand=14568171333334316645&h