Illusionist's Locket

Based on other deisgns, but fortified to print well without breakable joints.

NOTE: There are two versions of the bases. You'll want to get one of the three following setups:
Pill bottle version: locket_right_base_pill, locket_left_base_pill
locket: locket_right_base, locket_left_base
no hole for necklace: replace the right base with pill_right_base_nh or locket_right_base_nh

Pin will snap into place with soft PLA. Must move it around a little to get it to fully settle. Mine needed some coaxing and tapping. This aids in it lasting longer.