Thingiverse
Imperial Headset holder/wallmount
von Hertz5
3
Downloads
2
Likes
0
Makes
I wanted somewhere to hang my headset, and I like star wars, so this became a thing.
I put the screw holes on the underside for a more minimalist look and stronger design. You dont need screws tho, double-sided tape would do just fine, but the option is there, hence the length of it.
I printed it standing with supports everywhere for a better look on the imperial logo, and option for filament swap. I used standard supports because they took a little less time, but I think tree supports are worth the extra time, removing the supports was a pain. You could print it on the side, which would make it even stronger.
I put the screw holes on the underside for a more minimalist look and stronger design. You dont need screws tho, double-sided tape would do just fine, but the option is there, hence the length of it.
I printed it standing with supports everywhere for a better look on the imperial logo, and option for filament swap. I used standard supports because they took a little less time, but I think tree supports are worth the extra time, removing the supports was a pain. You could print it on the side, which would make it even stronger.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
