Thingiverse
"Impossible" Tube maze
von lordricker
16
Downloads
8
Likes
0
Makes
Coworker said the other maze on thingiverse was too easy so I made a harder one. This one is nigh impossible without the cheat sheet. Good luck!
Should print with no supports. I do recommend the inside part made of PETG since the nub rubs along and can wear out quicker if made out of PLA
Should print with no supports. I do recommend the inside part made of PETG since the nub rubs along and can wear out quicker if made out of PLA
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
