Improved Centauri Carbon Fan Silencer

This is a remixed model of leuma2's model from Nexprint. The original model chokes the air flow too much for the printer, and could burn out your fans. To replace these you have to tear apart the entire machine. I was worried about this, but I saw an oppurtunity with this model.I ripped out the inside and greatly increased the airflow passage, allowing for nearly no air resistance and still silencing the fan to a manageable level even at 100%. To install, you cannot use the screws on the back of the printer. You have to have a minimal of M3X6, anything lower than a 6 screw won't fit. Enjoy!