Thingiverse
Improved centre modules that require no gluing.
10
Téléchargements
10
Likes
1
Makes
As it's difficult to glue the three components to the triangular washers making it flimsy, I remixed in Tinkercad so that it can be printed in a vertical orientation.
It needs minimal supports, only at the base and the two deep grooves. It takes up little space so I was able to stack 6 on my Creator 3 and use Duplicate mode to make 12 of them (11 needed) in just over 12 Hours. They are very sturdy and will not break. Printed at 15% infill on Flashforge PLA.
The second part is the single one for the High Gain Antenna
It needs minimal supports, only at the base and the two deep grooves. It takes up little space so I was able to stack 6 on my Creator 3 and use Duplicate mode to make 12 of them (11 needed) in just over 12 Hours. They are very sturdy and will not break. Printed at 15% infill on Flashforge PLA.
The second part is the single one for the High Gain Antenna
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
