Improved Helmet Holder

I printed the helmet holder by deagudeloj last year, but I found the trestle design to be more decorative than functional, and the bottom screw was difficult to install due to limited space and no pass-through hole. So, I redesigned it with a flat shape, eliminating the need for beveled sides, and created a solid hanger with a pass-through hole for the bottom screw. This revised design saved time and filament while resulting in a stronger, easier-to-hang holder. The pass through hole is 12mm which allows for most extensions. As you can see in the photo I had to use two bit holders to get the job done and they didn't have any problems with clearance at all. Membership