Improved Screen Door Handle

I find it too hard to grab on to open my screen door. The latch takes up most of the room in the handle, and I have started to wear out the screen by grabbing the back side. This is a remix of the handle by aclymer. I have included his outside handle, although I did not modify that, But I wanted to make this a complete package if needed. I just went into Tinker-cad ad added a protrusion to make grabbing the handle easier.

After Printing I realized that these must have different sizes. The original handles from aclymer have holes that are 82mm apart, but it seems the ones I need are 80mm apart so I chomped a bit out of a model. You will see this as the 80mm version above. I recommend measuring your handle screw holes before printing.