Thingiverse
Impulse Sealer Knob
von markabyrd
2
Downloads
0
Likes
0
Makes
Found a 12" Impulse Sealer in the back of my shop that must have been dropped. After replacinng a broken microswitch (inside), new sealing wire and PTFE tape, new non-skid feet, only the broken handle remained.
See: https://www.amazon.com/gp/product/B01JGPZYWS for similar item
Had to drill out one of the two screws holding remnants of the broken phenolic handle. Printed the replacement in Carbon Fiber PLA (no supports).
Fusion 360 file included for use if needed.
See: https://www.amazon.com/gp/product/B01JGPZYWS for similar item
Had to drill out one of the two screws holding remnants of the broken phenolic handle. Printed the replacement in Carbon Fiber PLA (no supports).
Fusion 360 file included for use if needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
