Thingiverse
In-Drawer Knife Block
100
Downloads
67
Likes
0
Makes
Hey everyone!
I wanted a knife block that would fit in my drawer so I designed one in OnShape, and I figured someone else might want to use it as well!
It comes in two flavours, one with 3 slots (2 big knives, 1 small knife) or with 7 slots (4 big knives, 3 small knives).
You should be able to print it in the upright position without any supports, and it should fit in the CR10 print volume (300x300x400mm)
I wanted a knife block that would fit in my drawer so I designed one in OnShape, and I figured someone else might want to use it as well!
It comes in two flavours, one with 3 slots (2 big knives, 1 small knife) or with 7 slots (4 big knives, 3 small knives).
You should be able to print it in the upright position without any supports, and it should fit in the CR10 print volume (300x300x400mm)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
