Thingiverse
Incense Sticks Holder
von SSSR_SH
9
Downloads
17
Likes
0
Makes
Incense Sticks Holder
Bamboo-shaped Incense Holder
Total length: 230mm, width: 40mm.
It can accommodate incense sticks up to 20cm in length.
The insertion hole requires a 10mm long PTFE tube, recommended 4mm OD, 3mm ID.
If you are concerned about the high temperature at the end of the incense stick, you can dip it in water.
Printed without supports.
Bamboo-shaped Incense Holder
Total length: 230mm, width: 40mm.
It can accommodate incense sticks up to 20cm in length.
The insertion hole requires a 10mm long PTFE tube, recommended 4mm OD, 3mm ID.
If you are concerned about the high temperature at the end of the incense stick, you can dip it in water.
Printed without supports.
SSSR_SH veröffentlicht auch auf
225 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
