Thingiverse
Inception Totem (magnetic)
von ODDesign
5
Downloads
9
Likes
0
Makes
This is a small spinning top 'totem' from the movie "Inception"
I originally added an 8 x 3mm neodymium magnet to give it some weight to spin better but it gave the spinning top some neat characteristics
The magnet also helps to center the top and bottom halves when gluing them together
I have also added a "cooling tower" to print alongside this two-part print
It is designed to allow the tall slim part of the spinner to cool a little bit between layers, otherwise it may stay malleable while printing and cause some severe warping
Print in PLA with no supports and 100% infill on a glass bed for a perfect print
Enjoy!
I originally added an 8 x 3mm neodymium magnet to give it some weight to spin better but it gave the spinning top some neat characteristics
The magnet also helps to center the top and bottom halves when gluing them together
I have also added a "cooling tower" to print alongside this two-part print
It is designed to allow the tall slim part of the spinner to cool a little bit between layers, otherwise it may stay malleable while printing and cause some severe warping
Print in PLA with no supports and 100% infill on a glass bed for a perfect print
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
