Index Controller Charging Wallmount V2.1

A convenient wall mount to charge the Index controllers. The controllers sit in a balanced position allowing for the low profile and less material to print. It is stable, but the controllers could be knocked off easily enough it you have toddlers running around.

**Print it on it's back, i.e. the side facing the wall should face down on the printer. **

Requires [EEkiimy magnetic usb c cables](https://www.amazon.ca/EEkiimy-Magnetic-Multiple-Charging-1xCable-3xConnectors/dp/B07K9DHN4R) - other models or brands might not fit.

V2.1 updated usb cable routing, lowered magnet to make controllers sit better.

V2.0 first release, minor issues:
-cable guide is a bit brittle, could use reinforcing
-controller contacts charger magnet before being fully seated in the stand, so it feels a bit wobbly. I had the magnet 1 mm lower in the test design, but the controller didn't quite make enough contact to charge. Will try lowering 0.5 mm for v2.1