Thingiverse
Inductive/Capazitive Mount for E3D v6 Bowden Carriage
von TheZippyMan
23
Downloads
11
Likes
0
Makes
This is a remix of http://www.thingiverse.com/thing:638496.
It uses a 17/18mm inductive/capazitive ZProbe.
You will need to print a low profile fan duct for your E3D hotend.
Be sure to print this part at a 100% Infill, because the sensor doesn't seem to fit properly. Mine at 30% broke. To fit the sensor heat the part or the sensor a little bit up and thread it carefully into the part.
It uses a 17/18mm inductive/capazitive ZProbe.
You will need to print a low profile fan duct for your E3D hotend.
Be sure to print this part at a 100% Infill, because the sensor doesn't seem to fit properly. Mine at 30% broke. To fit the sensor heat the part or the sensor a little bit up and thread it carefully into the part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
