Thingiverse
Inductrix FPV+ prop saver
von JFs743
8
Downloads
6
Likes
0
Makes
Are you tired of your Blade Inductrix FPV+ props flying off? The central shaft most likely cracked, these little donuts keep the shaft tight so that they don't crack and fixes broken ones if they are printed just right.
This simple print uses roughly 5cm of filament.
This is my first design, I started simple, but fixed a real problem :D
This simple print uses roughly 5cm of filament.
This is my first design, I started simple, but fixed a real problem :D
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
