Thingiverse
IndyDrone V2 (2024 Version
von Dread_FPV
0
Downloads
0
Likes
0
Makes
Indydrone V2 2024 parts version
Update 05.09.2024:
As requested from Jason theres a 3d print to drill 19x19mm holes for the arms to use bigger motors: „indydrone v2 arm 19mm drill holes.stl“
print in PLA / PETG, drill holes are 3.15mm so it should fit perfectly for a 3mm / 3.1mm drill bit.
Use a metal drill bit, start with drilling in reverse, when you are through the first layer, drill in normal, don’t push to hard, when you get close to the end - reverse again and push the drill through to get a nice clean cut.
PSA: wear gloves and a mask when working with carbon, drill under water when possible, do not drill in the kitchen, your wife will hate you for that 😜
((File not tested - waiting for feedback))
Update 05.09.2024:
As requested from Jason theres a 3d print to drill 19x19mm holes for the arms to use bigger motors: „indydrone v2 arm 19mm drill holes.stl“
print in PLA / PETG, drill holes are 3.15mm so it should fit perfectly for a 3mm / 3.1mm drill bit.
Use a metal drill bit, start with drilling in reverse, when you are through the first layer, drill in normal, don’t push to hard, when you get close to the end - reverse again and push the drill through to get a nice clean cut.
PSA: wear gloves and a mask when working with carbon, drill under water when possible, do not drill in the kitchen, your wife will hate you for that 😜
((File not tested - waiting for feedback))
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
