Infill 3D Std. 3mm Geared Extruder

If you want a plain i3 standard geared extruder here it is, this extruder is based in Ch1to's model that is based in a Wade's extruder with the motor and gears rotated, I made the CAD model from scratch however I did follow his extruder, basically is Ch1tos work with minor improvements, I revise the geometry there where some minor errors for the screws and concentricity of the motor also I removed the need to use a M8 bar for the idler instead it uses a bushing and M3 screw and nut, there was a nut that lived on the inside of the idler removed it for a more conventional outside nut, added zip tie points for wiring, removed the mounting point for the duct in the front since the SunBurn has it's own duct and all my extruders are made with the SunBurn hotend in mind, small changes to make it a bit more aesthetically pleasing since I found the original too "Square" some other small changes that I do not remember.
You are going to need the X-carriage from my website http://infill3d.com/24