Infill speed test

Hello everyone,here is a small test I conducted to check the maximum infill speed on your 3D prints. I had some problems where the infill tended to slightly peel off, and with the upper layers, it ended up forming a bigger and bigger blob until the print head started to violently hit the print, and I had to cancel my prints.So, I reduced my infill speeds to a maximum of 150mm/s. I hardly had any more problems.So, I wanted to create a test to determine the maximum infill speed without it forming "blobs." I created these different shapes with different infill speeds, ranging from 100 to 300mm/s in steps of 50mm/s. I also made layer heights of 0.12, why? Because if I reduce my layer height, I can increase the print speed without being limited by the volumetric flow of my filament. Wall speeds were greatly reduced, which allowed the layer times to increase, giving them enough time to cool properly to avoid being limited by that parameter. The results showed that despite the fairly