Infill Swatches

These are a set of models that can be used to make swatches demonstrating various slicer infill patterns.

Note that the patterns are not present in the models themselves! Instead, you must set your slicer settings specifically to show the patterns. The models are simply labeled blocks. The labels match the infill patterns available in Cura 5.9.

You should use at least the following settings:

* Layer Height: 0.2 mm
* Top Thickness: 0 mm / 0 layers
* Bottom Thickness: 0.8 mm / 4 layers
* Infill Pattern: Match the name on the model
* Infill Density: 20–30%

I also recommend a filament change between layers 4 and 5 to highlight the labels and infill patterns.

The OpenSCAD source code, such as it is, is available at https://codeberg.org/asciipip/infill-swatches.