Thingiverse

Infinite Torture Cube v2

by z0333

8.9k Downloads

7.3k Likes

15 Makes

Go to Model

V2 of my [Infinite Torture Cube](https://www.thingiverse.com/thing:3526557).
This one is not for the faint hearted.
The clearance between the cubes is only 0.1mm.
I don't own a fancy high end printer. Just a simple I3.
Print SLLLOOOOOWWWW and reduce 3-5% of your normal extrusion rate.

Good Luck!

I've added a test link so you'll be able to tune your print settings before the real thing.
This is one of the more challenging parts within the model (to print and clean).
The connection link should face up.
Work with the direction of the hinges. Twist so the top sides of the cubes to face each other. The leg of the inner support will snap when you'll free the cubes.
The pyramid that support the link from below is hollow. Use a wire cutter to cut it tip. Insert the cutter to the hole in order to firmly grasp the pyramid from the side, and twist to free it from the link.

-- Update:
Uploaded supportless versions. Have fun:)

fidget Fidget Toy fun game infinity cube kobayashi kobayashi fidget cube overhang test overhang torture test printer torture test Torture Test fidget Fidget Toy fun game infinity cube kobayashi kobayashi fidget cube overhang test overhang torture test printer torture test Torture Test fidget Fidget Toy fun game infinity cube kobayashi kobayashi fidget cube overhang test overhang torture test printer torture test Torture Test

Source

Thingiverse

What you need to print this: Beginner Low confidence

Why?

no supports

Support-free Single piece

Supports 0/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer