Infinitely Growing Triangle

Meet the infinitely growing triangle! Separated into 4 pieces, it is easy and intuitive to assemble using peg connectors. Here are the four parts:Top: male connectors on one side. Only used once at the topEdge: male connectors on two sides. Used for edgesMale: male connectors on all sidesFemale: female connectors on all sides To start, print the starter triangle, but to expand, you need to print edge, male, and female pieces (see below). To build:Take the starter triangle pieces and connect a female piece to the top piece. To the left and right of the female piece, connect the edge pieces, with the male connectors facing the bottom. Then, connect these pieces separately (left to right): edge, female, male, female, edge. Make sure the additional connectors from the edge pieces are facing below. To add:For each layer, you need to add +1 male and +1 female to the amount you used for the previous layer. So to add a layer to the starter triangle, print 3 females and 2 males, and connect the