INGCO 20V Battery - Workshop Holder / Bracket

INGCO 20V (P20S) power tool battery bracket / mount, for holding/hanging your Ingco batteries up on the wall in your workshop space.

Batteries clip in place with the battery lock.

Features recessed countersunk screw holes.

Printed flat on the bed.

For the prototype prints shown I have just printed this with Sunlu PLA+, and Bambu Basic PLA, on my Bambu Labs X1C printer, printed on Textured PEI bed.
Supports are required just for the overhang where the battery slides in, very easy to remove and came off clean in my case. Use light supports that remove easily.
15-25% infill should be totally fine, these were printed with 20%, 4 walls, 4 top/bottom layers - for a bit more strength.