Inland PLA+ Reusable Spool

This is a remix of Inland_PLA+_spool_V2. I made this because the original hole of the spool was too large, which led to the spool hitting my z-axis knob. I added tiny holes on the spool, should you need to switch filament and store the one you're not using.
Note: You'll need to change your "Build Plate Adhesion Type" to "none" when printing on the Ender 3 (Pro) otherwise your part will be greyed out and not be able to be sliced on Cura.

- V2 file center hole diameter: 39 mm
- V3 file center hole diameter: 59 mm

How to assemble:

1) Remove your spooless Inland PLA+ from its packaging.
2) Insert the first half of the spool onto one side of the cardboard piece that holds the filament.
3) Insert the second half of the spool onto the other side.
4) Remove the paper or plastic straps that secure the filament. Make sure to remove the strap that holds the start of the filament at the very end otherwise the filament may unravel and tangle. The start of the filament should always