Thingiverse
Inmoov - MiddleChest - Wire Friendly
by CyberSyntek
9
Downloads
1
Likes
0
Makes
MiddleChest-PIRV1 - Wire Friendly version.
Large hole cut out of the bottom portion which will be located inside the robot (hidden) and save you a bit of filament/print time.
This will allow you to more freely run you PIR and Ultrasonic wires into the Kinect slot depending on your Kinect setup.
Large hole cut out of the bottom portion which will be located inside the robot (hidden) and save you a bit of filament/print time.
This will allow you to more freely run you PIR and Ultrasonic wires into the Kinect slot depending on your Kinect setup.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
