Inmotion P6 Mudguard Flap

Keep your backside clean with this easy "fix" for the P6. This model will most likely be updated when I'm able to test effectiveness more (upon winter tire install). Had all kinds of goofy ideas to make a better mudguard for this wheel, but oftentimes simple is the best option. This flap is a 1mm thick print, and utilizes the P6' existing geometry to form a more effective mudguard.

4 different files:

-"Top" file and "Bottom" file can be printed on a single plate, and will give the most coverage.
-The "OnePiece240" file can fit on many standard buildplates.
-"OnePiece270" for big boy machines.


Print and install:

-Use flexible material, tpu 98a or the like preferred.
-Remove mudguard to install, then add a single washer to each of the 4 screws. Install screws to the flap holes before seating into mudguard.
-Recommended to screw down the two centerline screws first, then move on to each of the two side ones.
-Push flap into mudguard, allowing the sides of the flap to follow the co