Innato GT3 Button Guard

The Innato GT3 wheel is a good unit for the price and it's unfortunate that they are no longer produced. That said, there are a few deficiencies that need addressing to make it a GREAT wheel. The biggest problem I had was when crossing-up (turning 180deg left or right) my thumb knuckle would hit the start/stop or pit-limiter buttons! (Additionally, in other files I uploaded are a too-small funky switch cap and shifter paddles set further in toward the wheel.) This button guard addresses the problem I had and replaces the stock ones while not impacting the button use whatsoever.

To install: Do these one at a time! Tightly grip the existing button-guard and turn counter-clockwise to loosen the captive hex nut 5-6 turns and then begin lifting it away from the wheel lightly. Once the nut is fully loosened (10-15 turns total) you can put your thumb over the button and with your finger-nails behind the guard, pull firmly towards you. Hopefully you didn't fling the nut and button a