Thingiverse
Inner Dimension Calibration Test
3
Descargas
0
Likes
0
Makes
Wanted a quick test for calibrating inner dimensions. On large prints, my ID was off as much as .0.8 mm, While my OD on all measurements were 0.1-0.2mm.
In Cura, you're going to be adjusting horizontal expansion to get those measurements dialed in.
If you scale, would suggest scaling by whole number factors.
In Cura, you're going to be adjusting horizontal expansion to get those measurements dialed in.
If you scale, would suggest scaling by whole number factors.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
