Inside The Minotaur's Maze

This is my first attempt at a hueforge so please be gentle. I was going for a very textured wispy kind of look on his fur and think it made the print a little more delicate than I would have liked but over all for a first attempt I'm happy with it. Project: Mino2.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Base Thickness of 0.48mmThe Max allowed Thickness is 2.24mm and the Actual Thickness is 2.16mmFilaments Used: PLA Black Transmission Distance: 0.5 PLA Chocolate Brown Transmission Distance: 0.3 PLA Light Grey Transmission Distance: 1 PLA White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #8 (0.72mm) swap to Chocolate Brown At layer #13 (1.12mm) swap to Grey At layer #19 (1.6mm) swap to White for the rest.