Slicer Discord
Instax Mini Frame Fridge Magnet – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Instax Mini Frame Fridge Magnet

von morty · Decor
2.1k Downloads
1.8k Likes
1.4k Makes
Zum Modell
Check out my newest frame! Update: Added corner pockets to hold photo in frame. My wife asked for frames for her photos to put on the fridge. After multiple attempts, I got to one that she approved of! The frame is held by four 6x2 magnets. I got them pretty cheap on Amazon. They are press fit, I use a hand clamp and squish them in if I can't get them seated completely. The magnets are outside of the area of the picture, so the picture does not interfere with the magnets. There is a recess to fit the picture. It needs support, but I have it dialed in to peel off very easily. Honestly getting the support off the build plate is more difficult. Boost MeA simple way to display small photos where you’ll see them every day. Give it a boost if you think it deserves a spot on the fridge!
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen