Thingiverse
Integrated 10mm Magnet Mounts
von BobGreenwade
27
Downloads
25
Likes
0
Makes
The Magnet Mounts that are part of neverworks's Cosplay Armor Helpers (link to the left) are cool, but designed to be glued to the pieces separately. Here are some versions that are designed to be integrated into your build.
One change I made was adjusting the size so the holes fit 10x2mm magnets, that being the size I prefer. (You probably prefer something else, so go ahead and change it!) The other change is designed to make it easier to design your build so it can be printed without supports.
The regular Mount works best when it's against the build plate. The other two are designed for placement further up in the build: "Upward" when the magnet is horizontal, to connect to a part above the build (in the orientation in which it's printed); and "Upright" when the magnet is vertical.
(I haven't yet figured out anything for diagonal placement, but these two will probably suffice.)
As with neverworks' original, the mount is designed to hold up to three magnets, depending on h
One change I made was adjusting the size so the holes fit 10x2mm magnets, that being the size I prefer. (You probably prefer something else, so go ahead and change it!) The other change is designed to make it easier to design your build so it can be printed without supports.
The regular Mount works best when it's against the build plate. The other two are designed for placement further up in the build: "Upward" when the magnet is horizontal, to connect to a part above the build (in the orientation in which it's printed); and "Upright" when the magnet is vertical.
(I haven't yet figured out anything for diagonal placement, but these two will probably suffice.)
As with neverworks' original, the mount is designed to hold up to three magnets, depending on h
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
