Interior design night table lamp

Sometimes it is good to do small, one day side projects to escape everyday routines.

I went to DIY store to buy some LED lamp that would be a bit more special than others. Project also requires cable and socket so I bought them as well. Turned out there was cable that matches bulb color hah.

After that, I took my time to design it and put it together. Whole process including designing it and creating 2D files for lasercutting took me one day. So I assume you will be able to replicate it with files already provided in one day easy.

Notes on building process:
Parts were cut out of 4mm plywood. Gaps left for pieces to go together currently are 3.64mm because lasercutter that I have access to, has kerf 0.36mm. This most probably will differ for each lasercutter so you might need to adjust those gaps. I was designing it so that it could be assembled without using glue.

Cut out the pieces and sand them with hand sander or just sandpaper from both sides. I used vacuum cleaner to